MAIN REMOTE CONTROL FUNCTIONS
Memory Button: Press this button to enter a- SPL Select Button: This button activates the
radio station to the AVR 430Os preset memory. First,EzSet function to quickly and accurately calibrate the
tune the desired station, and then press this button.AVR 430Os output levels. When the button is pressed
Within five seconds of when you see the stationOs you will then need to select between automatic EzSet
frequency flash in the Upper Display Line # and operation or using the remote as a manual SPL meter
in the on-screen display, press the numeric keys by pressing the ?/¤ Navigation Button o until
for the preset number between 01 and 30 that youyour choice appears in the remoteOs LCD display.
wish to assign to the station. (See page 33 for morePress the Set Button q to enter the setting, and
information.) then follow the instructions as displayed in the LCD
Stereo Mode Select Button: Press this buttondisplay. (For complete information, see page 26.)
to select a stereo listening mode. When the button is EzSet Microphone Sensor: The microphone
pressed so that SURROUND OFF appears insensor that is used by the EzSet system is behind the
the Lower Display Line$, the AVR will operate inthree slots at the top of the remote control. When
either a bypass mode with true, fully analog, two-using EzSet to calibrate the AVR 430, be certain that
channel left/right stereo mode with no surround pro-the slots are not covered. (See page 26 for more
cessing or with full bass management, as opposed toinformation on using EzSet.)
other modes where digital processing is always used.
When the button is pressed so that SURROUND Lens: The infrared emitters behind the plastic
OFF appears in the Lower Display Line$, andlens at the top of the remote communicate the remote
the DSP and SURROUND OFF Surroundcodes to the AVR 430. Be certain that the lens is not
Mode Indicators % are lit, you will enjoy a two-covered when using the remote, and point the lens
channel presentation of the sound along with the ben-toward the AVR for best results. In learning mode, the
efits of bass management. Depending on whetherremote receives IR codes to be learned through a
your system is configured for 5.1 or 6.1/7.1 chan-sensor behind the lens.
nels, the next press of the button will cause either NOTE: DO NOT remove the rubber plug that is supplied
5CH STEREO or 7CH STEREO toto cover the jack on the upper right side of the remote.
appear, and the stereo signal will be routed to all fiveThe jack is not active and is reserved for future use.
(or seven) speakers. (See page 31 for more informa-
tion on stereo playback modes.)
DTS Neo:6 Mode Select Button: Press this
button to select a DTS Neo:6 mode. (See page 31
for the available DTS Neo:6 options.)
DTS Digital Mode Select Button: When a
DTS-encoded digital source is playing, each press of
this button will scroll through the available DTS modes.
The specific choice of modes will vary according to
the type of encoding on the disc and your systemOs
speaker configuration. When a DTS source is not in
use, this button has no function. (See page 31 for the
available DTS digital options.)
Dolby Mode Select Button: This button is used
to select from the available Dolby Surround modes.
Each press of this button will select one of the Dolby
Pro Logic II modes or Dolby 3 Stereo. When a Dolby
Digital-encoded source is in use, the Dolby Digital
mode may also be selected. (See page 31 for the
available Dolby surround mode options.)
6-Channel/8-Channel Input Select: Press this
button to select the device connected to the 6- or 8-
Channel Direct Inputs40 . (See page 29 for more
information.)
14 MAIN REMOTE CONTROL FUNCTIONS |
ACEC
